Replies

Didn’t help the problem, Start menu displays for about 4 sec then disappears.

NM is on mountain time.

I had checked for updates via the settings and it said OS was current. Go figure.

I’m downloading and updating.

It says version 1511 (OS Build 10586.545)

Occurred after the upgrade to Windows 10, i.e. no restore point for 10.

Work around was specific to application, a different download that didn’t require the installer.

Yes, a number of the fixes I tried involved the safe mode so I’m familiar with the aspects of using it. But appreciate you notes about it.

Thanks Sudo15.

I found a work around for the app I’m installing but I’ll certainly give your suggestion(s) a try.

Thank you Rick! I appreciate the info.

You too Browni.

No, I’ll check with tech support next week. I’m sure nobody is there this weekend.

Thanks again.

Thanks for the quick reply JoeP.

It was included in PGI compiler download. The help info says it is Version 14.0.25123.00 Update 2 so sounds like it is later than the problems you note.

In the short term I’ve just added “-Minfo=all” to the compile command line.

Why not use GWX Control Panel? You don’t need to mess with the registry then.

Joe

Thanks Joe. Worked great.

I should note that it also fixed the “Upgrade to Windows 10” that had appeared in my laptop’s update control panel. That wouldn’t allow me to check for Windows 7 updates, it just set there and spun when I told it to look for updates.

Initial/new installation with no language choice, should have been English.

At reboot after the first part of the install error message simply said it could not find what language to install (the language package). Prior to that, nothing was ever said about a language during the install and it did communicate during the install.

Have installed Windows7 a number of different times on different computers and never seen this before.

An additional problem is that this is my sister’s computer and install was being done remotely (I’m 3000 miles away). Remote installs have work many times before as an Adm.

Asked another way, can I tag (connect) a symbol to a data point?

I should note that what I said earlier isn’t accurate, the Windows logo appears first then blank screen for hours. I assume avz is running.

avz.exe that was downloaded from Kaspersky to run. It starts after a reboot.